Also there are videos on the wed showing the axis sliders and operation of the table under courtjester90 have fun Tom I have the DXF files for the parts and the G-code for cutting them if you have access to a pasma cutter. Cost for the plans are $20.00 plus $3.50 shipping in the US P.S. The water table shown in the picture was barrowed from my other table which is smaller. There are also 20 minutes of tutorials on Sheetcam showing its operation for layering, positioning, nesting, and combining parts to be cut on the material. You add a computer and plasma of router to complete the setup to be fully functioning unit. It is setup with open end and a parking area in the X axis for easy material loading. This table is set up for cutting on a 4’ X 4’ sheet but simply changing the length and width a larger table can be built. The cost of building this table is about $1300. Clearly written including construction pictures in the instructions and more on the CDs showing positioning and assembly of the table and controller. Covered sections are from the table construction to the configuring of the computer and motor controls including floating torch head and water table. They are laid out so each section is covered by itself.
more plans come on CDs and are in PDF file format.
This is a very well constructed table with all the information supplied for you to build one yourself. Plans for DIY CNC table for plasma or router.